Mantis 7945 Betreibershandbuch PDF herunterladen (Seite 9)

9Contact us at www.mantis.com

• You’ll need the 2 Tines and the

2 retaining pins.

• Remove the unit from the

cardboard cradle and lay the

unit on its side.

• You will notice that one side of the

Tine has a circular hole while the

other has a “D” shaped hole.

TINE ASSEMBLY

1 2 3

Assembly (Continued)

• Attach the Tine so that the circular hole

slides onto the axle rst.

• When the axle protrudes from the

other side it will line up perfectly

with the “D” shaped hole.

4 5

IMPORTANT NOTE:

Be sure you have proper throttle movements and that

the throttle cable is not wrapped or twisted around the

handle bar. Hold down the lockout lever, fully squeeze

the throttle trigger and let go. The throttle triangle must

click in both directions. If there is any doubt, remove

air lter and visually check that the throttle triangle hits

both the idle screw and the full open stop. THIS MUST

BE DONE BEFORE STARTING THE ENGINE.

IMPORTANT NOTE:

Before you use your MANTIS Tiller, read the

Safety Rules & Warnings on pages 3-5

IMPORTANT NOTE:

Make sure you have installed the handles properly.

When you stand behind your tiller, holding the handles,

the fender warning label should face you.

Improper Throttle installation can cause tines to rotate unexpectedly.

7945

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Keine Kommentare

Mantis 7945 Betreibershandbuch Seite 9