Mantis "E" System Bedienungsanleitung

© 2006 Mantis, Div. of Schiller-Pfeiffer Inc. All Rights Reserved.Edger “E” SystemOwners Manual and Safety Instructions

91. Clean.2. Lubricate for rust prevention.3. Store indoor.Storage1. With both hands on the handles, push lockout triggerbutton with your thumb first,

10Service Maintenance GuideArea Maintenance procedure FrequencySpline male/female connection of theinner drive shaftInspect/Lubricate1. Remove the sid

1112346578201112242591013141516232218192126312928303227423941403433353637384443495848474651545556575352564550626061596317Edger “E” System Exploded Vie

KEY # DESCRIPTION PART # QTY1 GEAR CASE ASSEMBLY 331137 12 GEAR CASE 331138 13 O-RING 331139 14 BEARING 6201Z 331140 15 SEAL 331141 16 RING RETAINING

Specifications, descriptions, and illustrative material in this literature are as accurate as known at the time of publication, but are subject to cha

1Table of ContentsImportant InformationA. IntroductionThis attachment is fitted with a blade, intended to be used toedge flower beds, sidewalks, drive

2Safety and WarningsA. Safety DecalsPlease pay particular attention to the warning and informationdecals found on various parts of this Edger Attachme

3General Safety Rules1. Never edge while people, especially children or pets arenearby.2. Before using, always visually inspect to see that the blade,

Length (feet) 1 to 25 26 to 50 51 to 100 101 to 150Cord gauge (AWG) 18 16 14 124b. Based on the total length of cord that you are going to use, check

5WARNING – DANGERIMPROPER ASSEMBLY OF THIS EQUIPMENTCAN RESULT IN SERIOUS INJURY. MAKE SURETO FOLLOW ALL INSTRUCTIONS CAREFULLY.IF YOU HAVE ANY

6Tools: 9/16" wrench, pin supplied with the unit orscrewdriver1. Remove the following parts from the Edge TrimmerAssembly: blade mounting bolt #1

7Check the balance of the assembled unit. The handles andshoulder harness have been assembled at the factory and setaccording to the average sized per

8Tools: 9/16" wrench, pin or screwdriver1. Lock the gear shaft by inserting the pin or screwdriverthrough the aligned keyholes in the gear case c